_25_11_2024_15_40_33.jpg)
|
Socoder -> Blitz -> colour fading? |
|
| Mon, 14 May 2007, 05:42 | |
spinal
|
I'm attempting to fade a palette to black (and later back again) but I seem to be doing something wrong. Can someone take a look and tell me? If I set num_fade_frames to anything other than 60 it looks crap, perhaps i'm not calculating the step properly? -=-=- Check out my excellent homepage! 
|
| Mon, 14 May 2007, 05:58 | |
Blitz3Dman
|
I'm looking at the code now and noticed you spelled close wrong in a comment for a delay command 
-=-=- There are 10 kinds of people in this world - ( Insert 16 remarks about to what extent people know hex here ) |
| Mon, 14 May 2007, 06:03 | |
|
spinal
|
The 'L' key on my laptop has been a bit of a pain lately, I usually notice when that happens.
-=-=- Check out my excellent homepage!
|
| Mon, 14 May 2007, 06:05 | |
|
Blitz3Dman
|
I found the problem. Many of your color values are less than num_fade_frames so that color does not fade. Here I replaced 120 with 51 and it works nicely. Although, I also had to change in your loop where you had For s=0 to num_fade_frames+1. The loop does the fading 2 more times than it should. It needs to be For s=1 to num_fade_frames. -=-=- There are 10 kinds of people in this world - ( Insert 16 remarks about to what extent people know hex here ) |
| Mon, 14 May 2007, 06:12 | |
|
spinal
|
 Many of your color values are less than num_fade_frames so that color does not fade. Any ideas on fixing that? besides changing the number of frames? This will be used on images etc, so I will have very little say in what the palette will be. -=-=- Check out my excellent homepage!
|
| Mon, 14 May 2007, 06:25 | |
|
Blitz3Dman
|
You'd have to go through the pallet and find the lowest value and use it probably BTW I found that you need to have instead of For s=1 to num_fade_frames you need to plop a -1 right at the end. -=-=- There are 10 kinds of people in this world - ( Insert 16 remarks about to what extent people know hex here ) |
| Mon, 14 May 2007, 08:37 | |
Jayenkai
|
Easiest way to solve it, is changing all the dimmed values to floats, instead. That way your maths works a little better. Otherwise, try playing about with this. -=-=- ''Load, Next List!''
|
| Mon, 14 May 2007, 16:48 | |
|
spinal
|
I thought of that while I was at work. I realized some of the smaller values would have steps of less than 1. Perhaps I should think more about work though, while I'm there.
-=-=- Check out my excellent homepage!
|
| Mon, 14 May 2007, 16:52 | |
|
Jayenkai
|
Nah.. No point doing that.. You'd never get your fading working if you did that!
-=-=- ''Load, Next List!''
|
| Mon, 14 May 2007, 17:20 | |
|
spinal
|
It seems palib has a bitghtness setting for specific palettes, I might not need to learn anything after all. (I usually run ideas through blitz as I know basic a better than I know C, also its a bit quicker to see results). Anyway, I off to bed, it's tomorrow already.
-=-=- Check out my excellent homepage!
|
|
|
| |||
|
| ||||