|
Socoder -> Cobra -> Value clipping help |
|
| Sat, 20 Feb 2010, 09:50 | |
HoboBen
|
I think I'm too sleepy, can't get this to work... For a slider gui element, I want to clip the slider to certain values, e.g. every tenth of the bar. This works: offset = offset - (offset mod (width/(divisions-1))) However, this always clamps to the lower value. I'd like to clamp to the nearest value, meaning sometimes I need to clamp upwards. Any ideas? -=-=- blog | work | code | more code |
| Sat, 20 Feb 2010, 12:05 | |
JL235
|
Something like... is what I think would work. Index refers to which of the sections the slider is located in, from 0 (inclusive) to divisions (exclusive). So if the width is 100, and there are 5 divisions, then the increment is 20. The first position (at index 0) is 10 (20/2 + 0*20) whilst the last position (at index 4) is 90 (20/2 + 4*20). Hope that helps! |
| Sat, 20 Feb 2010, 12:34 | |
|
HoboBen
|
Thanks very much! I managed to work on it and got this Result!!! 
-=-=- blog | work | code | more code |
| Sat, 20 Feb 2010, 16:00 | |
|
Sticky |
Do you really need the else of the if-then-else there? Setting a value to itself is effectively a no-op. -=-=- last.fm 
|
| Sun, 21 Feb 2010, 00:33 | |
Jayenkai
|
It was probably a leftover from a trial+error thing. I leave loads of those things all over the place!
-=-=- ''Load, Next List!''
|
| Mon, 22 Feb 2010, 10:52 | |
|
HoboBen
|
Oops, turns out it's "slider.sliOffset = slider.sliOffset - o3"... don't know how that disappeared!
-=-=- blog | work | code | more code |
|
|
| |||||
|
| ||||||
